1, injection molding machine settings

o The raw material drying temperature is consistent with the traditional molding

o The barrel plasticizing temperature is higher than traditional injection molding

o The mold temperature requirement is strict, and the cooling water circuit layout should balance the cooling effect

o Injection pressure is basically the same as traditional injection molding

o Injection speed is generally high-speed filling

o injection molding machine injection pressure can be disabled

2. Setting of high-pressure nitrogen equipment

a, the maximum pressure of the high pressure nitrogen generator is generally set not more than 35Mpa

b. Parameter setting of nitrogen pressure controller (gas pressure, gas holding time, lifting pressure rate, start delay)